Category: Nintendo
-
Sanyo 20EZ Video Inversion (Parts Kit) Searchable Page
On Bob Roberts site, there is (or was, if the link is broken by the time you read this) a scan of a page that details how to add the missing parts to the Sanyo 20-EZ monitor chassis to allow it to perform video inversion. Since the page was scanned and not run through an…
-
Punch-Out vertical foldover/overdraw
The Punch-out that I recently obtained has a monitor issue (a monitors issue, really). Both displays are bring drawn starting ~2″ from the bottom of the monitor, and the upper few inches are being overdrawn on the same horizontal plane. In other words, the beam is scanning left/right correctly but is starting too low and…
-
Punch-Out
Problem: Dead Purchased a Punch-Out in dead condition. Got it home, still dead. Rocking the game and/or whacking the sides a bit got a brief flash of light on it so I went in and reconnected all connectors. Game then came up right after that. A little adjustment to the micro-switch arms and the game is…