Differences

This shows you the differences between two versions of the page.

--- assembly [2020/05/28 10:37]
jtwine
+++ assembly [2020/05/29 15:19] (current)
jtwine [Position the DS1233 Device]
@@ Line 31: / Line 31: @@
 **BEFORE YOU PLACE THE DEVICE** \\
 **BEFORE YOU PLACE THE DEVICE**\\
-There is an error on the silkscreen on the v1.4 of the **6809** version and v1.0 of the **Custom** version.  The device needs to be mounted opposite of how it is shown on the silkscreen.  That is, when looking at the parts side of the board, with the text upright, the flat side of the device should face to the **left**, not to the right as indicated on the silkscreen.
+There is an error on the silkscreen on the v1.4 of the **6809** version and v1.0 of the **Custom** version.  The device needs to be mounted opposite of how it is shown on the silkscreen.  That is, when looking at the parts side of the board, with the text upright, the flat side of the device should face to the **left**, not to the right as indicated on the silkscreen.  The square pad, which is closer to the top of the board, is for Pin 1.
 Now, place and solder the DS1233 device in the parts side of the board.  If you use the thru-hole version, there are two different ways to mount it.  If your socket is tall enough, you should be able to mount the device flush against the parts side of the board, right in its silkscreened position, and it should not protrude above the socket and interfere with the CPU being inserted into it.

JRTwine Low Voltage Reset Circuit