Differences

This shows you the differences between two versions of the page.

--- setup_statements [2020/02/15 17:57] – created adminz
+++ setup_statements [2020/11/17 03:59] (current) – [SetupPodTimeout] adminz
@@ Line 1: / Line 1: @@
 ===== Setup Statements =====
-First we start with the statements that are used for configuring the unit and the compile environment.
+Here we start with the statements that are used for configuring the unit and the compile environment.
 ==== SetupPod ====
@@ Line 113: / Line 113: @@
 ==== SetupPodTimeout ====
-This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation.
+This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation.  As of right now, there is no description for how long a single "count" of this value is.
- As of right now, there is no description for how long a single count is.serial line length used when transmitting serial data.  This is an important setting when sending/receiving hex data from the 9010A unit as longer lines lessen the effectiveness of the per-line checksum.
 It has a range of 6-60000.  If not specified, the default value is 200.  This is equivalent to the ''TIMEOUT'' setup parameter in 9LC.