This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
setup_statements [2020/02/15 11:58] adminz |
setup_statements [2020/11/16 21:59] (current) adminz [SetupPodTimeout] |
||
---|---|---|---|
Line 113: | Line 113: | ||
==== SetupPodTimeout ==== | ==== SetupPodTimeout ==== | ||
- | This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation. | + | This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation. As of right now, there is no description for how long a single "count" of this value is. |
- | As of right now, there is no description for how long a single count is.serial line length used when transmitting serial data. This is an important setting when sending/receiving hex data from the 9010A unit as longer lines lessen the effectiveness of the per-line checksum. | + | |
It has a range of 6-60000. If not specified, the default value is 200. This is equivalent to the ''TIMEOUT'' setup parameter in 9LC. | It has a range of 6-60000. If not specified, the default value is 200. This is equivalent to the ''TIMEOUT'' setup parameter in 9LC. |