10LC Wiki

User Tools

Site Tools

Trace:
setup_statements

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
setup_statements [2020/02/15 11:58] – adminzsetup_statements [2020/11/16 21:59] (current) – [SetupPodTimeout] adminz
Line 113: Line 113:
  
 ==== SetupPodTimeout ==== ==== SetupPodTimeout ====
-This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation.  +This configures the amount of time the 9010A should wait for a connected Pod to respond to a requested operation.  As of right now, there is no description for how long a single "count" of this value is.
- As of right now, there is no description for how long a single count is.serial line length used when transmitting serial data.  This is an important setting when sending/receiving hex data from the 9010A unit as longer lines lessen the effectiveness of the per-line checksum.+
  
 It has a range of 6-60000.  If not specified, the default value is 200.  This is equivalent to the ''TIMEOUT'' setup parameter in 9LC. It has a range of 6-60000.  If not specified, the default value is 200.  This is equivalent to the ''TIMEOUT'' setup parameter in 9LC.
setup_statements.txt · Last modified: 2020/11/16 21:59 by adminz